Tripolar RF Treatment:
• Perform Tripolar RF treatment first (to improve blood circulation and maximize serum absorption).
• Apply a thin, even layer of gel to the entire area to be treated using your fingers.
• Spread evenly with your fingers.
• Press the “Play” icon on the screen, then press the ON/OFF button on the handpiece. The green indicator indicates standby.
• When the machine is ready for treatment, the indicator light will turn blue.
• Hold the handpiece perpendicularly and make small circular motions.
• Start at the jawline.
• When the end point is reached, the indicator light will turn orange.
• If the end point is still not reached after 1-2 minutes, increase the intensity level. However, do not increase the intensity level by more than 5%.
• Work area by area until the end point is reached.
• If time permits, return to the desired focus area, such as smile lines.
• If the patient has very thin or sensitive skin, use a low intensity treatment.
• After treatment, clean any remaining tripolar gel with a sponge and clean water (warm water if available).
• Then, pat dry with a soft tissue.

For the Oxygeneo treatment:
• Pour the serum appropriate for the patient’s condition into the capsugen cap (fill the entire serum).
• Select the treatment duration and intensity according to the default. Then press “Play.”
• To begin the treatment, press the “start” button on the handpiece.
• Work on the eye area first because the capsugen is still soft, so the patient will not feel any pain or stinging. For the eye area, advise the patient to open their eyes so that the under-eye area can be optimally treated.
• Use circular or linear movements for approximately 2 minutes (eye area, temples, and forehead).
• Once finished, dry the under-eye area with a dry tissue (to prevent the gel from getting into the eyes).
• Time specified (default time: 10 minutes for NeoRevive and 8 minutes for NeoBright). For sensitive skin, 4-6 minutes may be used (all face).

For Ultrasound Treatment:
• Attach the ultrasound handpiece to one side or replace the RF handpiece with the ultrasound handpiece first.
• Apply the serum using a brush to the entire area to be treated.
• Select the ultrasound treatment, then set it to low for areas close to the bone and high for the cheeks. Set the duration to approximately 10 minutes for the entire face.
• Press the “Play” and power buttons on the handpiece to start the treatment.
• Use circular or linear motions with light pressure on the skin surface (use gentle pressure, but avoid excessive pressure, especially near the bone).
• After the time has elapsed, a pop-up message will automatically appear on the screen. Click “Done” to proceed to the next menu.

Note: If the ultrasound handpiece indicator light is orange, it indicates that the gel is low/out of use or the therapist has left the handpiece out of contact with the skin for too long (not in use and in the ON position). The handpiece displays an error code with an orange indicator light.

For the Neomassage treatment:
• Attach the massager head to the handpiece.
• Apply the serum using a brush to the area to be treated.
• Set the Neomassage treatment duration and intensity, then press “Play.”
• Massage gently over the entire face.
• Use circular or linear motions evenly over the entire face.
• Before the treatment is complete, the operator will hear a “BEEP” sound. Continue the treatment until complete.

Treatment and product use will be adjusted according to the indications (Brightening, Anti Aging, Oily skin and Acne)

Healthier and more nourished skin (Revitalize)

The “3-in-1” approach: Geneo+ combines exfoliation (removing dead skin cells), infusion (introducing active ingredients), and oxygenation (improving skin oxygenation) in one treatment session. Other treatments typically focus on just one or two of these steps, resulting in less comprehensive results than Geneo+.

Instant brightening and hydrating